□ Today Main

Inspection and maintenance before moving out of the bus before the vehicle should make the following checks (failure to promptly at maintenance, troubleshooting, or not out of the vehicles):

1, oil, fuel, cooling water, brake fluid and power-storage milk electrolyte storage.
2, leakage, oil spills, leakage, leakage situation. 3, driver's license, driving permits and other necessary travel documents.
4, lighting, signals, horn, wipers, mirrors, door locks, windows and doors and hand the handle of the complete completeness and effectiveness.
5, the automotive exterior bolts, nuts and fastening of complete state.
6, steering devices and connecting rods of the reliability and flexibility, hand-brake foot brake and clutch working condition.
7, officers were on board are reasonable, trailer, or semi-trailer towing equipment reliability, attendant equipment and complete the degree.
8, start the engine, observe the engine operating conditions (instruments working condition and sound).

□ teach you a move

Do not 4 before moving maintenance

A. Do not tire bolt nut oiled

Maintenance of the wheel, a small number of private car owners in order to prevent rust on the wheel bolt nut, bolt installation ingenuity to the nuts are coated with lubricating oil, does not know that this practice is not only wrong, but also to bring some traffic safety risks. Tighten bolts and nuts after each other with self-locking features. And coated with lubricant, the coefficient of self-locking between the two smaller, self-lock performance. High-speed driving in the car, the bolt nut is easy to loose or even fall off, causing the accident. 

B. Do not wash with water body within the

Although he is already autumn, but the temperature is still high, common private car owners wash their side of the water body within the side of the wipe with the rag, in which private owners would like to remind is: is best not to water directly to the internal body wash. Because beneath the cab floor pad is not "Yimapingchuan" structural need to make the cab floor pad below the groove, through-hole is very large, water washed, or dry deposition in the groove is not easy, either from the pass hole in the gearbox and other components flow to generate rust. In particular, a better sealing performance sedan a more direct wash water can not be inside the body. The correct way is to use a wet rag and wipe, but to avoid accumulation of water. 

C. Different brands of coolant do not mix

Everyone knows that lack of engine coolant should be added in time, but do you put a different brand of coolant mixed use it? If so, advise you to let go, or early as possible to the cooling fluid, re-add the same brand coolant. Because different brands of cooling fluid may be significant differences between their chemical properties, such as an effective preservative for ferrous metals, aluminum products are often corrosive effect; preservatives applied to aluminum alloy is detrimental to the alloy. Since different brands of coolant preservative used in different, or mix. 

D. Do not step on the gas EFI car boot

Start the engine throttle before the foot Jijiao the habit of many drivers, especially in the cold start. However, this approach does not apply to start EFI cars. Device is equipped with electronically controlled fuel injection engines with common carburetor engine is different from its fuel injection control device according to the engine temperature, oil supply automatically adjusts the amount of conditions, so that the engine a smooth start, that is cold starts, Injection control system can automatically increase the oil supply. Therefore, the EFI car engine starts, there is no need to step on the gas, but also anxious not to step on before the start of a continuous, or else bad but the engine started.

Source: Chengdu Daily